Netgear Router Not Working? Do This!

Why is my router not working? Do you have the same query in your mind due to non-workability of your router? Read this blog to get help. Mentioned in this blog are various reasons why your Netgear WiFi router is not working and various solutions to get it up and working in no time. This is for your information that the solutions presented here work pretty same for any other router brand.

Why is My Netgear Router Not Working?

There can be several reasons that can prevent your WiFi router from working as intended. Some of the most common causes have been highlighted below. We suggest you go through the reasons so that you can narrow down to the root cause so that it can be easily eliminated.

  1. The router is not connected to the modem or internet gateway in a proper manner.
  2. Your router is not booted up due to fluctuations in power supply.
  3. You haven’t updated the router’s software.
  4. Faulty cables and wires are the most common cause.
  5. Your router’s setup is not executed in the right manner.
  6. Internet outages from your ISP end is another reason.
  7. A glitch in the network can cause your router to stop functioning.

So, this is all about some typical reasons due to which you are complaining about your Netgear router not working properly. The next section will walk you through the relevant and effective solutions that you should apply so that your router begins providing you with seamless internet signals.

What to Do When Your Netgear is Not Working?

We are going to mention certain general troubleshooting tricks that can be used when the router stops working. Before anything else, contact your ISP to confirm if internetoutages are causing this problem. In the event of no internet outages begin by rebooting the router.

How to Reboot Netgear WiFi Router?

  1. Turn off the router using its Power on/off button.
  2. Unplug its power cable.
  3. Let it rest for a couple of minutes.
  4. Plug it back and turn it on using the Power button.

The router should be working now. In case it does not use the next fix.

Supply Sufficient Electricity

Your WiFi router if not receiving adequate power can get stuck in the reboot loop due to fluctuations in the power supply. We suggest you plug the router into another socket.Perhaps the one into which it is plugged in now is not working correctly. Another thing that you should do is to verify the power cable. It shouldn’t be damaged or loose. Your router should be working now. Log in using IP 192.168.1.1 or URL routerlogin.net to update its firmware.

Fix Router-Modem Connection

The WiFi router connects to the internet modem or gateway with the help of an Ethernet cable. The cable that you have used should be in good condition. If it is not up-to-mark, then use another cable to make the connection. While connecting the devices, it is to be ensured that the cable is neither loose nor inserted into the wrong ports.

Perform Factory Reset

When everything else fails to help you make your router in workable condition, then the final option is to reset it to the default settings. To reset the router, follow these steps:

  1. Remove any devices connected to the router using the LAN cable.
  2. Insert a pointed object with a sharp end inside the Reset pinhole.
  3. Hold the button till the lights get stable back.

Verdict

Post resetting the Netgear router, you should configure it once again. Make a secure LAN connection between the router and modem and connectyour computer to the router’s network using a LAN cable. Log in using routerlogin.net and execute the on-screen prompts to complete router setup. We expect that the Netgear router not working trouble will be a thing of the past after you have given it a new start.